How To Fix Leaky Faucets At Commercial Areas In Kensington San Diego?
Plumbing problems are never fun, but they seem to happen at the worst times. If you have a leaking faucet at your commercial property, it can cause all sorts of problems. Not only will it waste water (and money), but it can also be disruptive to your business and customers.
Thankfully, there are a few simple things you can do to fix a leaky faucet. In this article, we’ll show you some ways to fix your leaky faucets at commercial areas.
Check The Washer First
If your faucet is leaking from the spout, the chances are that the problem is with the washer. Over time, Washers can become worn out or damaged, which will cause them to leak.
To check the washer, start by shutting off the water supply to your faucet. Then, remove the handle and unscrew the nut that holds the washer in place. Once you have access to the washer, inspect it for any signs of wear or damage. If the washer is damaged, it will need to be replaced.
Replace The O-Ring
If the washer is not the problem, then it’s likely that the O-ring is damaged or worn out. The O-ring is a small rubber ring that helps to seal the connection between the valve seat and the stem. Over time, these rings can become hard and brittle, which will cause them to leak.
To replace the O-ring, start by shutting off the water supply to your faucet. Then, remove the handle and unscrew the nut that holds the O-ring in place. Once you have access to the O-ring, simply remove it and replaced it with a new one.
Clean Or Replace The Valve Seat
If the O-ring is not the problem, then it’s likely that the valve seat is dirty or damaged. The valve seat is a small metal disc that sits at the bottom of the faucet. Over time, this disc can become corroded or clogged, which will cause it to leak.
To clean or replace the valve seat, start by shutting off the water supply to your faucet. Then, remove the handle and unscrew the nut that holds the valve seat in place. Once you have access to the seat, inspect it for any signs of corrosion or damage. If the seat is damaged, it will need to be replaced. However, if it’s just dirty, you can clean it with a toothbrush and some vinegar.
Tighten Up The Packing Nut
If your faucet is leaking from around the handle, it’s likely that the packing nut is loose. The packing nut is a small metal nut that helps to seal the connection between the stem and the handle. Over time, this nut can become loose, which will cause the faucet to leak.
To tighten the packing nut, start by shutting off the water supply to your faucet. Then, remove the handle and unscrew the packing nut with a wrench. Once you have access to the packing nut, simply tighten it down with the wrench.
Replace The Stem
If your faucet is leaking from around the stem, it’s likely that the stem itself is damaged or worn out. The stem is the small metal rod that goes from the handle to the valve seat. Over time, this rod can become corroded or damaged, which will cause it to leak.
To replace the stem, start by shutting off the water supply to your faucet. Then, remove the handle and unscrew the nut that holds the stem in place. Once you have access to the stem, simply remove it and replaced it with a new one.
Conclusion
There you have it! These are some ways to fix your leaky faucets at commercial areas. If you have a leaking faucet, don’t despair. With a little bit of know-how and some elbow grease, you should be able to fix it in no time. For more information, contact Plumber Kensington San Diego at (619) 535-1088.
